Thingiverse
Raspberry Pi Camera Mount ender3 Pro
by MellowDuck
37
Downloads
15
Likes
1
Makes
This is a Remix of https://www.thingiverse.com/thing:4350729
I made this remix to fit an Ender 3 pro, original design was for a regular Ender3. I extended the clip of the mounting area and also made room for the Y motor belt to run without interruption. I also used the same idea at the original by including supports on the modified section that should remove easily once printed.
Pictures are from an early test print.
I made this remix to fit an Ender 3 pro, original design was for a regular Ender3. I extended the clip of the mounting area and also made room for the Y motor belt to run without interruption. I also used the same idea at the original by including supports on the modified section that should remove easily once printed.
Pictures are from an early test print.
MellowDuck also publishes on
25 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
