Raspberry Pi Camera Stand/Mount

This is my raspberry pi camera stand. The print consists of 6 parts and you should print them all if you want my setup. Either use more reliable 3x25mm nuts and bolts (I used an M3 x 0.5 bolt) or print the hinge. You may need to use a drill or something else to make the hole a bit larger to fit the hole, but I found a 0.25 mm tolerance to work for most FDM printers, so this is what I used for my tolerances. I used atleberg's snap-fit cover and the hinges there (because modeling hinges in TinkerCAD is easy but boring) and added a lot of stuff.

Please note: **Pi Camera Stand Model.stl is just for you to understand how it works. Don't print it, there's a 99.9% chance it will not work.**

Try printing Hinges.stl with a smaller layer height so it fits easier. Most printers go up 0.04 mm per step, so try only layer heights with multiples of 0.04. You can try without it, it's still around the same, but a 0.28 mm layer height probably works a bit better than a 0.27mm layer height.

I de