Thingiverse
Raspberry Pi Camera V2.1 case
door AntonioGPS
51
Downloads
27
Likes
1
Makes
This is a design of a Raspberry v2.1 camera (8Mpx) case I did it for the fun of designing with Fusion 360.
There are two versions of the front cover. A pinned one that holds the camera with bars, and another one that allows to use 1.5mm screws (suitable for smartphones and the like) for permanently holding the camera into the case.
I also include a support with a 4mm threaded hole that can be used to fix the case any other supports, and a lens cap to keep the lens clean and protected when not in use
There are two versions of the front cover. A pinned one that holds the camera with bars, and another one that allows to use 1.5mm screws (suitable for smartphones and the like) for permanently holding the camera into the case.
I also include a support with a 4mm threaded hole that can be used to fix the case any other supports, and a lens cap to keep the lens clean and protected when not in use
AntonioGPS publiceert ook op
15 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
