Thingiverse
Raspberry Pi Camera V2.1 case
von AntonioGPS
51
Downloads
27
Likes
1
Makes
This is a design of a Raspberry v2.1 camera (8Mpx) case I did it for the fun of designing with Fusion 360.
There are two versions of the front cover. A pinned one that holds the camera with bars, and another one that allows to use 1.5mm screws (suitable for smartphones and the like) for permanently holding the camera into the case.
I also include a support with a 4mm threaded hole that can be used to fix the case any other supports, and a lens cap to keep the lens clean and protected when not in use
There are two versions of the front cover. A pinned one that holds the camera with bars, and another one that allows to use 1.5mm screws (suitable for smartphones and the like) for permanently holding the camera into the case.
I also include a support with a 4mm threaded hole that can be used to fix the case any other supports, and a lens cap to keep the lens clean and protected when not in use
AntonioGPS veröffentlicht auch auf
15 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
