Thingiverse
Raspberry Pi ClusterHat Case
door ck3mp3r
3
Downloads
1
Likes
0
Makes
This is a Raspberry PI case that doesn't necessarily adhere to any form factor usually attributed to a Raspberry PI.
I needed a case that would fit a ClusterHat on a new Raspberry PI 4. I designed my own as I couldn't find anything here on thingiverse. The idea was to make it look nice enough to be able to be showcased on a desktop if necessary.
It should fit all PIs 2/3/4. I've only tested it with a 4 however. The can is large enough to have hats installed. This one in particular was designed to house the ClusterHat and have enough room for cables. Cables are routed through the air vents at the bottom.
There are 3 vents at the bottom and holes on the lid, creating a chimney effect that should ensure sufficient passive cooling.
I've printed using transparent PETG, making for a cool look as the LEDs shine through.
PLA and ABS should print fine as well...
I needed a case that would fit a ClusterHat on a new Raspberry PI 4. I designed my own as I couldn't find anything here on thingiverse. The idea was to make it look nice enough to be able to be showcased on a desktop if necessary.
It should fit all PIs 2/3/4. I've only tested it with a 4 however. The can is large enough to have hats installed. This one in particular was designed to house the ClusterHat and have enough room for cables. Cables are routed through the air vents at the bottom.
There are 3 vents at the bottom and holes on the lid, creating a chimney effect that should ensure sufficient passive cooling.
I've printed using transparent PETG, making for a cool look as the LEDs shine through.
PLA and ABS should print fine as well...
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
