Thingiverse
Raspberry Pi Ethernet Mount
von wihami
3
Downloads
3
Likes
0
Makes
These prints allow one to install a Raspberry Pi Camera mount to their Raspberry Pi without needing to print an additional case. This is done by mounting the pi by a block placed in the ethernet port of the Pi. The rod used to attach the mounting pieces was 5/16" aluminum rod and the bolt at the top is an M3 x 10 mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
