Thingiverse
Raspberry Pi Stacking Mount
door crazybob1215
17
Downloads
5
Likes
0
Makes
The original version by MechJack was very slightly undersized for me and I couldn't get it properly sized even after printing a few at different scales.
This version is sized exactly for the Pi 4, but works with no issue for a Pi 3B that I have.
2020/03/21, Update 1: Added a label piece. I just write on it with a contrasting sharpie, but I could see putting tape on it first to provide a better writing surface or just emboss text on the flat side with the modeling software of your choice.
This version is sized exactly for the Pi 4, but works with no issue for a Pi 3B that I have.
2020/03/21, Update 1: Added a label piece. I just write on it with a contrasting sharpie, but I could see putting tape on it first to provide a better writing surface or just emboss text on the flat side with the modeling software of your choice.
crazybob1215 publiceert ook op
15 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
