Thingiverse
Raspberry Pi Wall Mount
von danrubel
16
Downloads
10
Likes
0
Makes
Derived from https://www.thingiverse.com/thing:39693
First printing... didn't work quite right:
1) I need to make it just slightly longer and wider so that the RPi can more easily fit. This mounts on a wall and thus the holder cannot flex that much.
2) The notches in the 4 corners need to be a bit higher off the surface and the notches a bit bigger vertically, again so that the board can more easily fit.
First printing... didn't work quite right:
1) I need to make it just slightly longer and wider so that the RPi can more easily fit. This mounts on a wall and thus the holder cannot flex that much.
2) The notches in the 4 corners need to be a bit higher off the surface and the notches a bit bigger vertically, again so that the board can more easily fit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
