Thingiverse
Raspberry Pi zero case
door lord_potato
16
Downloads
9
Likes
0
Makes
The bottom of this case was borrowed from another project, linked in the source files. I only designed the top for it, because I couldn't find a good looking top, that has ventilation holes (I know, it's not that important for the zero, but still), and has cutouts for not only the 40 GPIO pins, but also the four pins next to it (composite video and reset switch).
The picture is pretty bad quality, and my print wasn't as successful as it could be, but I'm loving it. I'm planning on spray painting it, it helps a lot.
The picture is pretty bad quality, and my print wasn't as successful as it could be, but I'm loving it. I'm planning on spray painting it, it helps a lot.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
