Thingiverse
Raspberry Pi Zero (W) Atari-Like Case
49
Downloads
55
Likes
0
Makes
Inspired by [It Doesn't Have to Look Like Raspberry Pi Zero Case](https://www.thingiverse.com/make:1055067) - kudos!
# About
After reconstruction work I added:
- an abstract RGB ATARI logo
- shaft cutout for GPIO pins
- Memory heat sink cutout (unfortunately a bit off from the actual memory center but enough for transferring heat properly, it's more esthetics...
# Print Settings
The model was printed at 208° (Nozzle) and 50° (build plate heat).
- Nozzle size: 0.4mm.
- Path width: 0.35mm.
- Layer height: 0.15mm
- Raft height does not matter but should be used to protect the outter shell during remove.
# RGB Support
You can download my python library GPIObench to the raspberry (will work from scratch) in that folder run for instance "python3 rainbow.py" and specify the pins (default: 3.3V, R=2, G=3, B=4). You can then specify to start this script during boot by opening "sudo crontab -e" and adding the start command above at the end.
# About
After reconstruction work I added:
- an abstract RGB ATARI logo
- shaft cutout for GPIO pins
- Memory heat sink cutout (unfortunately a bit off from the actual memory center but enough for transferring heat properly, it's more esthetics...
# Print Settings
The model was printed at 208° (Nozzle) and 50° (build plate heat).
- Nozzle size: 0.4mm.
- Path width: 0.35mm.
- Layer height: 0.15mm
- Raft height does not matter but should be used to protect the outter shell during remove.
# RGB Support
You can download my python library GPIObench to the raspberry (will work from scratch) in that folder run for instance "python3 rainbow.py" and specify the pins (default: 3.3V, R=2, G=3, B=4). You can then specify to start this script during boot by opening "sudo crontab -e" and adding the start command above at the end.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
