Raspberry Pi Zero W Case plus Camera

I needed a small simple shaped case for a Raspberry Pi Zero W for use in creating a timelapse, initially in my allotment polytunnel but subsquently found it useful to stick to windows using the 3M Command Poster Strips. Couldn't immediately find an existing design so I designed my own using Solidworks 2020.
I didn't want screws or snap together features.
The camera used is the Raspberry V2.1 and the small bump over features in the front case to retain the camera were customised for the actual part I had which measured 25mm (the V1.3 camera I also have measures 24.7mm so this is a bit l loose if used but still retains it.
When assembling, take care to make sure the camera lens outer case is located in the square cutout in the case, it does tend to move.