Raspberry Pi Zero W / Makerbot Replicator 2/2X Corner Camera Case

Case to mount a Raspberry Pi Zero W and Pi Camera to the front inside corner of the Makerbot Replicator 2/2X. The purpose of this is to see if print is complete, and remotely monitor the print.

Inspiration drawn from: https://www.thingiverse.com/thing:2254307

Features:
- The case mounts to the inside M6 bolt of front left corner frame, when using a longer bolt.
- Vent holes top and bottom
- Camera is pointed to center of build plate (X-Y) and 10 degrees down (Z).
- Electronic components are all mounted to case front for easy removal. Besides the power cable, there are no other cables to route through the Replicator 2.

Note:
The camera ends up being a little low in reference to the build plate due to needed clearance of the gantry. The print doesn't become visible until about 5mm of height.

Additional Parts: (specifics to follow soon)
Raspberry Pi Zero W
Raspberry Pi Camera
Micro-USB to DIP Board
M6 longer bolt and nut.
M3 bolt and nut

For case back Print bol