Raspberry Pi4 Case
von olialb
142
Downloads
69
Likes
2
Makes
Based on the great design of anjanathisal I created this case with the following changes:
- More venting holes on top bottom and sides to allow more air flow
- Holes for screws to fix the case that its not accidentally opening
- Add screw cylinders to case top to fix the PCB inside
- Make the case 2mm higher to give some space to add ons inside
I have here two variants. One has an additional hole for a antenna connector. I use it for my HM-MOD-RPI-PCB ELV module. Its for my openhab homematic integration.
Update 2019-12-05:
The temperature in the passive cooled housing (using my openHAB configuration) was still over 60 degrees Celsius. I decided to add a top cover with fan... Now its arround 42 degrees with the fan connected to 3.3V!
- More venting holes on top bottom and sides to allow more air flow
- Holes for screws to fix the case that its not accidentally opening
- Add screw cylinders to case top to fix the PCB inside
- Make the case 2mm higher to give some space to add ons inside
I have here two variants. One has an additional hole for a antenna connector. I use it for my HM-MOD-RPI-PCB ELV module. Its for my openhab homematic integration.
Update 2019-12-05:
The temperature in the passive cooled housing (using my openHAB configuration) was still over 60 degrees Celsius. I decided to add a top cover with fan... Now its arround 42 degrees with the fan connected to 3.3V!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
