Raspberry Pi4 Case
di olialb
142
Download
69
Likes
2
Makes
Based on the great design of anjanathisal I created this case with the following changes:
- More venting holes on top bottom and sides to allow more air flow
- Holes for screws to fix the case that its not accidentally opening
- Add screw cylinders to case top to fix the PCB inside
- Make the case 2mm higher to give some space to add ons inside
I have here two variants. One has an additional hole for a antenna connector. I use it for my HM-MOD-RPI-PCB ELV module. Its for my openhab homematic integration.
Update 2019-12-05:
The temperature in the passive cooled housing (using my openHAB configuration) was still over 60 degrees Celsius. I decided to add a top cover with fan... Now its arround 42 degrees with the fan connected to 3.3V!
- More venting holes on top bottom and sides to allow more air flow
- Holes for screws to fix the case that its not accidentally opening
- Add screw cylinders to case top to fix the PCB inside
- Make the case 2mm higher to give some space to add ons inside
I have here two variants. One has an additional hole for a antenna connector. I use it for my HM-MOD-RPI-PCB ELV module. Its for my openhab homematic integration.
Update 2019-12-05:
The temperature in the passive cooled housing (using my openHAB configuration) was still over 60 degrees Celsius. I decided to add a top cover with fan... Now its arround 42 degrees with the fan connected to 3.3V!
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
