Thingiverse
RaspberryPi3 Mk3 Case
von jsada_xyz
559
Downloads
306
Likes
18
Makes
I modified hackoholic version for adapt it to Original Prusa Mk3 and the Raspberry Pi 3 B.
Changes:
- When I printed other version I broke L2 regulator of a Raspberry Pi 3 B because the case pressed it so I reduced the surface that is in contact with the raspberry.
- Mk3 framework is narrower than the Mk2s so a couple of millimeter of case were inside printer area and could be touched bu extuder cables during the print. I modified to make this part fit with the framework.
- I added some holes in the "bottom" of the case in order to get a better heat dissipation.
I'm using it with Raspberry Pi 3 B+ and Prusa MK3.
It should be compatible with Raspberry Pi 2, Rapsberry Pi 3 B and also Prusa Mk2s.
The screws are from spare parts of Mk3 (4 x M3x18 and 2 x M3x10)
Changes:
- When I printed other version I broke L2 regulator of a Raspberry Pi 3 B because the case pressed it so I reduced the surface that is in contact with the raspberry.
- Mk3 framework is narrower than the Mk2s so a couple of millimeter of case were inside printer area and could be touched bu extuder cables during the print. I modified to make this part fit with the framework.
- I added some holes in the "bottom" of the case in order to get a better heat dissipation.
I'm using it with Raspberry Pi 3 B+ and Prusa MK3.
It should be compatible with Raspberry Pi 2, Rapsberry Pi 3 B and also Prusa Mk2s.
The screws are from spare parts of Mk3 (4 x M3x18 and 2 x M3x10)
jsada_xyz veröffentlicht auch auf
15 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
