Thingiverse
Rathcore Plug
von GrumbleBumpkin
4
Downloads
2
Likes
0
Makes
# Introduction
Simple plug for a Rathcore painting handle. Allows for blue tack or magnet mounting without messing with the corks that come with the handle.
It is recommended that this is printed on FDM printers as it relies on compressing the flanges in order to remain in the handle.
Tested using a Rathcore V3 Grip.
## Updates
- v2: made the draft angle slightly smaller for a tighter fit in the handle.
Simple plug for a Rathcore painting handle. Allows for blue tack or magnet mounting without messing with the corks that come with the handle.
It is recommended that this is printed on FDM printers as it relies on compressing the flanges in order to remain in the handle.
Tested using a Rathcore V3 Grip.
## Updates
- v2: made the draft angle slightly smaller for a tighter fit in the handle.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
