RC Glider

This is a modified version that can be printed on Bambu lab. The wings have a hole for carbon fiber arrow shaft ID 6.2 sp300 which is about 7.7mm outside diameter.I increased the length of the nose by 50mm. I had to put more than 100g of ballast in the nose of the first plane.The pictures are from the first plane. I have print the parts for this one, but it will take some time for me to assemble it.The firewall is for Dualsky XM3045EG, I used this one.Everything is printed in PetG and glued with CA glue. The first plane was flying wery well but I have crashed it because I lost the RC signal. My mistake, I just trow the receiver inside the fuselage next to the ESC and all the servo wires. Now I made two holes for the antennas on the fuselage. All the files are atached as Raw Model Files… Note:This is not a model for a first build. You will need some experience.And I will not make an assambly guide, I don't have time. I'm just sharing what I have made for me.Have fun…