Slicer Discord
RC Hovercraft – 3D-Druckmodell von Thingiverse Thingiverse

RC Hovercraft

von q2slinger
58 Downloads
55 Likes
0 Makes
Zum Modell
Micro R/C hovercraft with single propeller. This was made from the wreckage of a ultra-micro 2S R/C airplane. It uses foam for the skirt material so it can only be run on a smooth surface.

NOTE: Not kid or pet friendly with exposed propeller.

Maximum time at full throttle time in this video was about .1 seconds. This thing is very fast. Run time is around 6 minutes.


Parts
Micro Servo
Brushless motor
200mAh 7.4V Battery
5x2.75 Propeller
6 Channel Ultra Micro Receiver and ESC There are much cheaper options available.
Foam Backer Rod
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Schleifen
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen