RC Jet Boat

My fully printable RC Jet Boat. The two hull parts must be glued together and can be precisely positioned thanks to the holes for using 3mm screws.The hood is designed to fit into the hull using two hooks at the front, while at the rear there is a hole for using a 12mm long 3mm screw. A strip of adhesive foam (typically used to hermetically seal windows) should be used along the edge to prevent water from entering the hull. In my project, I used a 2440 brushless motor and corresponding ESC, both liquid-cooled, so the hull has a hole at the bottom front and one at the rear. This allows the water to circulate through the duct and cool the parts perfectly.I used a kit similar to this one:https://it.aliexpress.com/item/1005009301601606.html Unfortunately, kits and sizes change frequently, and some kits are no longer available after a short time. So, I designed the motor mount to be interchangeable (glued to the hull). So, if you find a different kit or the sizes are different, you can simp