Thingiverse
RC Plane CG Posts
von Angry_Red_Wasp
3
Downloads
2
Likes
0
Makes
I designed these to easily find the CG of my Flite Test Legacy V2. The Legacy V2 has two holes in the wing to support the plane to find the CG.
Designed in three parts, print two of each then glue together. The clearances are a little loose so even if your printer isn't perfectly calibrated you won't have problems getting them together.
The base parts have optional holes for #10 flat head wood screws so you can mount them to a piece of wood or whatever you want if you so choose.
Total height from base to tip is 14" (355mm) to give room for the larger Flite Test planes with landing gear. (My Legacy V2 measures about 13" (330mm) from gear to wing bottom).
The tip is 3/16" diameter (about 4.75mm) and is rounded to act as a pivot point.
Designed in three parts, print two of each then glue together. The clearances are a little loose so even if your printer isn't perfectly calibrated you won't have problems getting them together.
The base parts have optional holes for #10 flat head wood screws so you can mount them to a piece of wood or whatever you want if you so choose.
Total height from base to tip is 14" (355mm) to give room for the larger Flite Test planes with landing gear. (My Legacy V2 measures about 13" (330mm) from gear to wing bottom).
The tip is 3/16" diameter (about 4.75mm) and is rounded to act as a pivot point.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!