Thingiverse
RC Stand
por sd_042
10
Descargas
5
Likes
0
Makes
I broke my Duratrax car stand, so rather than get another, I designed one. It's not much, but should do the trick.
My old one was mounted into a wood block so I made screw holes to mount this one. To make it higher, this one has two levels and is made to hold the aluminum bearing from my original one.
It came out good. I used a hammer and wood block to tap in the bearing.
My old one was mounted into a wood block so I made screw holes to mount this one. To make it higher, this one has two levels and is made to hold the aluminum bearing from my original one.
It came out good. I used a hammer and wood block to tap in the bearing.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!