Rem Pod

if using the file named base_with_better_band_support.stl then this has built in supports that need removing, it is where the rubber band slots in.

I designed this to use the MadLab MLP105 Electronic Kit, Junior Theremin as it works the same way as a rem pod and this thing works great, do change the antenna to a telescopic one, this is designed to use a 5mm or 6mm one at the base, I printed mine with abs but pla will work just as good, only use support if the file name mentions support, one file has tpu in the name so use tpu or or other rubber based filament for that part, it is used to push the antenna through so if it gets damaged then just pull out the old and solder the wire to a new one and push back in, its friction fit, use 4 x 5mm leds, two 6mm or 7mm buttons on the top and the power switch is a 20mm simple on off switch, it is powered by a 9v pp3 battery which is mounted on the base and uses an elastic band to hold it in place, I planned to fix the pcb to the side of the in