Thingiverse
Remote Case
door dgdimick
14
Downloads
4
Likes
0
Makes
I wanted the ability to print ABS, PTEG, and Nylon, printing these filaments require your printer to be in an enclosure. The enclosure is needed to keep the filament and print warm while it's being printed; if the print cools too fast it will split, or become lose from the print bed. Electronics running at a high temperature, such as inside a heated enclosure, causes them to degrade, lowering there service life, a solution is to place the electronics in a remote location away from the heat. With this in mind, I designed these 3 cases. These cases will allow you to decide where you want to place your electronics, for them to remain cool, as well as a location that is out of the work area.
I've created cases for the Creality main board, Big Tree Tech SKRv1.3 board, and the Raspberry Pi 3B+ board.
The "Master" or main case is the Raspberry Pi case, you then use one of the two cases as a mate, and this completes a full enclosure.
Version 1.5 - Added a 6.5mm wall to the face of the
I've created cases for the Creality main board, Big Tree Tech SKRv1.3 board, and the Raspberry Pi 3B+ board.
The "Master" or main case is the Raspberry Pi case, you then use one of the two cases as a mate, and this completes a full enclosure.
Version 1.5 - Added a 6.5mm wall to the face of the
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
