Remote Control Caddy

This simple caddy for two remotes is easy to print. The version in the photo included with this post was printed on a Qidi X-Smart at a .30 layer height with 15 percent infill at 100mm/sec in a little over 3 hours. Print it at a .16 layer height at lower speeds for a perfect print.

The seam is on the front because that side of the model was facing the back in Cura. Face the bracket side to the back and the seam will not be visible.

The model was created in Tinkercad and is located here:

https://www.tinkercad.com/things/hiCCytbDQTR

I used this model in a couple of videos on the DrVAX YouTube channel. Here is a link to one of the videos:

https://youtu.be/JTKDMdgRmv8