Remote Control Holder

Remote Control Holder I designed to attach to a glass patio/garden table I have in the lounge. You might find other uses for the clips or the base. I recommend printing it The holes in the bottom of the base are just in case you put something in like a phone and can't get it out from the top. My iPhone 7 is about the perfect size to get stuck, hence the holes. LOL.

Print the clips with 3 perimeters and 50% infill with a 20 perimeter zero offset brim.
Print the base upright, with supports under the base, and a 20 perimeter zero offset brim to avoid warping. The large support area should be one solid layer for the base layer, then 10% infill from there on out.

Holes in the clip and base are to stop it sliding if the fitment isn't tight enough. Just add some short self tapping screws or bolts of 3mm wide and about 10mm long.