RemoteHolder

This remote control holder is sized for the remotes I have, plus spaces for a wireless telephone bas & phone and some reading glasses. It may or may not work for similar devices you have, but I got a request to post it, so here it is.

Be aware that I had a problem printing this - perhaps because I was using the latest Alpha 2 test version of PrusaSlicer 2.5.0. The problem had to do with Infill, which had never cause me a problem before. Normally I specify 12% triangular infill, but when I did that my printhead crashed into some of the infill lines just before printing the top layers of the base. To fix this I tried several different infill patterns and % values, but all of them resulted in the same problem.

I finally gave up and specified Infill = 100%. This brute force technique worked fine and the print completed OK in just under 17 hours using a layer height of 2.03 mm and a print speed of 110 mm/sec.