Slicer Discord
Replacement Crocs Strap – 3D printable model from MakerWorld MakerWorld
Clothes

Replacement Crocs Strap

169 Downloads
56 Likes
110 Makes
Go to Model
A replacement strap for Crocs, UK men's size 11/EU size 46, it will probably work for close sizes like 9-13.I printed in TPU-95.I suggest you face the print bed side towards the foot when fitting the strap to the shoe, so the smoothest surface is touching the foot to prevent blisters/chaffing. Also this allows the less densely printed top skin to stretch to accommodate the curvature of the strap.It takes quite some force to push the strap button through the strap hole, I managed with just my fingers and a lot of force. You may want to use a tool like circlip or needle nosed pliers to assist with stretching the strap hole when attaching the strap if your fingers are not strong. Warming up the end of the strap in a cup of freshly boiled water for 2 minutes makes putting the strap on much easier.
Category
Clothes
Source
MakerWorld
Published
Updated
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
PLA, TPU
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection