Slicer Discord
Replacement Crocs Strap – 3D-Druckmodell von MakerWorld MakerWorld
Clothes

Replacement Crocs Strap

169 Downloads
56 Likes
110 Makes
Zum Modell
A replacement strap for Crocs, UK men's size 11/EU size 46, it will probably work for close sizes like 9-13.I printed in TPU-95.I suggest you face the print bed side towards the foot when fitting the strap to the shoe, so the smoothest surface is touching the foot to prevent blisters/chaffing. Also this allows the less densely printed top skin to stretch to accommodate the curvature of the strap.It takes quite some force to push the strap button through the strap hole, I managed with just my fingers and a lot of force. You may want to use a tool like circlip or needle nosed pliers to assist with stretching the strap hole when attaching the strap if your fingers are not strong. Warming up the end of the strap in a cup of freshly boiled water for 2 minutes makes putting the strap on much easier.
Kategorie
Clothes
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, TPU
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen