MakerWorld
Other House Models
Go to Model
Replacement Gear - Magic Bullet Blender
39
Downloads
7
Likes
23
Makes
Print files for 6.0 mm & 8.5 mm brass inserts available.Boost MePlease leave a free BoostAfter going through three blenders due to worn out gears, I finally designed this replacement part.So I wont have to keep replacing the whole unit!I reused Brass Female Thread Insert Embedment Nut. Assembly Instructions: Allow the part to fully cool before assembly.Insert the part into the printed component by pressing it in using pliers.Use a piece of cardboard or other protective material between the pliers and the plastic to avoid damage.Do not apply heat, this part is designed for a cold press fit.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
