Thingiverse
Replicator 2X Active Cooling
von ten13th
76
Downloads
55
Likes
1
Makes
An active cooling solution for printed filament of both printer heads of R2X. It reduces curling of corners and smaller parts on ABS prints.
The fan is powered by external USB power supply, like a USB phone charger, or powered USB port on computer. I decided to go with an external power source, so I don't have to monkey with the R2X electronic.
With this design, when installed properly, it will clear all internal R2X parts within the normal range of travel.
The two photos with the red sphere printed in MBI PLA shows the difference in result between with and without active cooling for PLA printing.
The fan is powered by external USB power supply, like a USB phone charger, or powered USB port on computer. I decided to go with an external power source, so I don't have to monkey with the R2X electronic.
With this design, when installed properly, it will clear all internal R2X parts within the normal range of travel.
The two photos with the red sphere printed in MBI PLA shows the difference in result between with and without active cooling for PLA printing.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
