Thingiverse
RepRap Stencil
von polymaker
50
Downloads
79
Likes
3
Makes
Make your mark!
I included all the files created in the process. I started out using Gimp for the initial design, then saved that to svg and did the rest of the work in inkscape. In retrospect, I think I made this a lot harder than it needed to be, especially considering that the open source hardware logo comes in SCAD format.
I got the RepRap teardrop from here: http://reprap.org/wiki/RepRapLogo
and the open hardware logo from here: http://oshwlogo.com/
I'm not sure what the license is on these, so I just used a generic creative commons license.
I included all the files created in the process. I started out using Gimp for the initial design, then saved that to svg and did the rest of the work in inkscape. In retrospect, I think I made this a lot harder than it needed to be, especially considering that the open source hardware logo comes in SCAD format.
I got the RepRap teardrop from here: http://reprap.org/wiki/RepRapLogo
and the open hardware logo from here: http://oshwlogo.com/
I'm not sure what the license is on these, so I just used a generic creative commons license.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
