Resized Protogen Head Electronics Frame

Decided to make a protogen head, but I needed to print it at 110% size due to my *enlarged cranium*

These are a collection of parts I resized and edited to still fit the original components, will not fit original frame size.

It includes 2x fan grill (one for 40mm fan, one for 30mm fan) because I originally had a 12v 40mm fan running on 5v. Didn't work too well. So I replaced it with a 5v 30mm one that works a bit better. Just used some M3x15mm Hex head nuts and bolts to secure it.

Also includes a face frame and frame mirror, with some janky edits to still accommodate the 8x8 LED Matrices used. These were wired up before being secured in place with some dabs of hot glue. Hopefully makes removal easier if needed.

Also includes a 2mm wire organizer clip. This is tiny, and printed in a large quantity. Used some side cutters (wire cutters) to clean up any stringing and cut them down from 5 wire to smaller as needed. Wire was laid in the clip as needed, and dabs of superglue used