Thingiverse
ReSpooling Tool
0
Downloads
0
Likes
0
Makes
A simple print for holding an empty spool using a carriage bolt and nut to use a drill for re-spooling filament.
Print 2.
Required hardware
1- 5" 1/4"-20 carriage bolt
1- 1/4"-20 Nut
Sandwich the empty spool between the two printed parts on the carriage bolt. Tighten the nut down until everything is snug and place the end of the bolt in the drill chuck.
Print 2.
Required hardware
1- 5" 1/4"-20 carriage bolt
1- 1/4"-20 Nut
Sandwich the empty spool between the two printed parts on the carriage bolt. Tighten the nut down until everything is snug and place the end of the bolt in the drill chuck.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!