Thingiverse
ReSpooling Tool
von RustyShovel33
0
Downloads
0
Likes
0
Makes
A simple print for holding an empty spool using a carriage bolt and nut to use a drill for re-spooling filament.
Print 2.
Required hardware
1- 5" 1/4"-20 carriage bolt
1- 1/4"-20 Nut
Sandwich the empty spool between the two printed parts on the carriage bolt. Tighten the nut down until everything is snug and place the end of the bolt in the drill chuck.
Print 2.
Required hardware
1- 5" 1/4"-20 carriage bolt
1- 1/4"-20 Nut
Sandwich the empty spool between the two printed parts on the carriage bolt. Tighten the nut down until everything is snug and place the end of the bolt in the drill chuck.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!