Thingiverse
RF link case
von Dropjeslover
0
Downloads
2
Likes
0
Makes
A case for an Arduino 2560 and the RF link expansion.
Cut-outs for the power, USB-A female and 1 RF link antenna
Cut outs are under a 30/60° angle so no support needed.
Wall thickness is 1,5mm
Cut-outs for the power, USB-A female and 1 RF link antenna
Cut outs are under a 30/60° angle so no support needed.
Wall thickness is 1,5mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
