RF100 better cable routing

It happens that the upper cable to the extruder breaks. What happened to me.
I ordered the replacement cable from the manufacturer and didn't want to install it in the same position again.
First I removed the old cable, that's a bit tricky but no problem.
I drilled a hole in the bottom right back of the cable with about 15mm-20mm and laid the cable in a nice big bend. The cable is held by my clip.
I hope the problem with the cable is solved.

Link to the cabel
https://www.conrad.de/de/kabelbaum-passend-fuer-renkforce-rf100-1522166.html