Thingiverse
Rfid card reader Case
door ISHAVEYOU
7
Downloads
8
Likes
0
Makes
A case to make a RFID card Reader for a 7inch touchscreen and a RC522 Card reader at the indentation. To screw everything together you use three M2x46mm bolts to hold everything together and a M2x10 mm bolt to hold the raspberry pi to the case. This was for my matura project. There is a place where you can put you power bank to power this project.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
