Thingiverse
RigidBot Part Fan
von pyrohmstr
32
Downloads
13
Likes
0
Makes
A part fan mount for a RigidBot single extruder (might work on a double). I like it because it keeps the fan out of the way.
The bracket leaves just enough room to hit the tension lever with a screwdriver and it screws down using the two screws for the bearing.
It's designed to be used with this fan: https://www.amazon.com/dp/B00H8VV0XK/ref=cm_sw_su_dp
but others may work.
The duct works well and doesn't blow on the hot end enough to matter. It snaps into place but I don't trust it so I used tape just to be sure.
Finally, the fan mount poles have a hole in them near the end for a pin or a bar to hold the fan on. I used a rubber band and it works fine.
Update 10/2016: Fixed the scaling issues. Should work without any scaling now.
The bracket leaves just enough room to hit the tension lever with a screwdriver and it screws down using the two screws for the bearing.
It's designed to be used with this fan: https://www.amazon.com/dp/B00H8VV0XK/ref=cm_sw_su_dp
but others may work.
The duct works well and doesn't blow on the hot end enough to matter. It snaps into place but I don't trust it so I used tape just to be sure.
Finally, the fan mount poles have a hole in them near the end for a pin or a bar to hold the fan on. I used a rubber band and it works fine.
Update 10/2016: Fixed the scaling issues. Should work without any scaling now.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
