Thingiverse
Ring Lamp (Customizable)
di geit_de
1.6k
Download
1.3k
Likes
3
Makes
There is a V2 of this model: https://www.thingiverse.com/thing:4877991 (Dual)
There is a V3 of this model: https://www.thingiverse.com/thing:4904677 (Halo)
Ok, this is the result of a small FreeCAD session: A little ring lamp with 325mm diameter. You need a printer with around 200x200mm build plate to be able to print a quarter ring.
Key Features:
When designing this I had some key features in mind:
° simple and clean print
° avoid the led strips glue tape on the back at all cost.
° add a simple compartment for the electronics.
° wire management
° easy to print.
° no flimsy pegs to mount, which fail printing or break away later on.
Requirements:
1x 5V power supply
1x Power Connector
1x Switch
1x LED strip. (60 pixel/m or more)
WARNING! You need a LED strip without a rubber dome. Just the plain flexible PCB with the LEDs and resistors soldered on.
I used a 60 pixel/mm strip and ended up using 57 LEDs in total.
Printing:
You need to print a the s
There is a V3 of this model: https://www.thingiverse.com/thing:4904677 (Halo)
Ok, this is the result of a small FreeCAD session: A little ring lamp with 325mm diameter. You need a printer with around 200x200mm build plate to be able to print a quarter ring.
Key Features:
When designing this I had some key features in mind:
° simple and clean print
° avoid the led strips glue tape on the back at all cost.
° add a simple compartment for the electronics.
° wire management
° easy to print.
° no flimsy pegs to mount, which fail printing or break away later on.
Requirements:
1x 5V power supply
1x Power Connector
1x Switch
1x LED strip. (60 pixel/m or more)
WARNING! You need a LED strip without a rubber dome. Just the plain flexible PCB with the LEDs and resistors soldered on.
I used a 60 pixel/mm strip and ended up using 57 LEDs in total.
Printing:
You need to print a the s
geit_de pubblica anche su
79 modelli aggiuntivi su altre 1 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
