Ring Stand

My wife wanted a small ring stand to put by the sink. There were reasons that she could not use any of the ones on Makerworld, so here we have a openSCAD, parametric model . It can deal with any size plate, and any finger size. If you needed a ring wand that was 300mm long you could make one. In the program I have the US ring size table, European table, and several others. However, those functions are incompatible with the customizer so I set the size range for the smallest US ring size to the largest US Ring size. This code is open source - it is public domain and no warranty. If you want to boost me if you sell one, great. If not, that is fine too. The code is a mess, it is very simple. Today I replaced the code. It is properly indented, has a few comments, fewer misspellings, I fixed some formatting issues that affected the customizer messed with the way fillets were produced and added the ability to produce a base that was not round, and I changed it to not put fillets on the outer