Thingiverse
RingStep010
von Marlyn
3
Downloads
3
Likes
0
Makes
New machine? Wondering how accurate it is?
Step #1. Design a "calibration" thing.
Step #2. Print it.
Step #3. Pull out calipers and see how it did.
This is a ring of 24 segments where each succesive segment is stepped .010" (about 2.5mm) in height.
Segments are hollow to save on filament.
Inner ring height is .25"
Step #1. Design a "calibration" thing.
Step #2. Print it.
Step #3. Pull out calipers and see how it did.
This is a ring of 24 segments where each succesive segment is stepped .010" (about 2.5mm) in height.
Segments are hollow to save on filament.
Inner ring height is .25"
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!