RiteSpec Wing Extensions

These are 1/4 wing extensions for the RiteWing Spec Wing v2. These wing extensions were requested by members of The RiteWing Nation Facebook Group. Once installed they should get you the sweep as prescribed by the FPVWRA. These ARE NOT WINGLETS, these are airfoil extensions. For best results print at 15% infill. 2 or 3 top layers, 2 or 3 bottom layers and 1 outer perimeter. My test prints were 3g a piece for a total of 6g weight addition, not factoring in glue weight. Print on blue tape to get them to adhere to the bed, and more importantly, it gives you a rough surface to glue onto. Goop or foam safe CA will be fine. I haven't done any testing other than the fitment in the photos. PLA, PETG, ABS, your choice, experiment with the print settings to get the lightest possible extensions. For questions regarding FPVWRA rules and guidelines, please consult their page. I will not answer those questions here. Feedback on the design is welcome.