Thingiverse
Robotics
Zum Modell
Robot Arm
59
Downloads
80
Likes
0
Makes
This is my 4 axis robot model.
1/10th scaled from an ABB IRB660.
You will need 3x MG995 Servos and1 x SG90 Servo.
You will need 6 x 606zz bearings.
I used an Arduino Uno to control it.
My gripper is not very good so I need to make a new one.
All holes are smaller than needed and will need drilling out to size.
Video can be seen here https://youtu.be/70WXJGAknr4
1/10th scaled from an ABB IRB660.
You will need 3x MG995 Servos and1 x SG90 Servo.
You will need 6 x 606zz bearings.
I used an Arduino Uno to control it.
My gripper is not very good so I need to make a new one.
All holes are smaller than needed and will need drilling out to size.
Video can be seen here https://youtu.be/70WXJGAknr4
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
