Thingiverse
Robot
door jce129
20
Downloads
14
Likes
0
Makes
This was an experiment to see if I was able to design and print an action figure with movable joints print in-place.
The action figure came out fine albeit a bit loose in some of the joints. Further adjustment will be needed to fine-tune the joints.
The action figure came out fine albeit a bit loose in some of the joints. Further adjustment will be needed to fine-tune the joints.
jce129 publiceert ook op
3 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
