Thingiverse
Robot
door KyleStall
5
Downloads
11
Likes
0
Makes
The Right and Left LimbUppers need to be printed twice. Once for shoulder and once for thigh. The connector needs to be printed twice regular and then twice rotated 180 degrees so the ball connectors are up instead of down.
To get the connectors to fit you need to press pretty hard, I did not do the best job on the tolerances but once you get it in place it will fit without being loose.
The gcode file has all the pieces ready to go but with my printer I could not get that to print all at once without it failing. I had to print each piece individually.
To get the connectors to fit you need to press pretty hard, I did not do the best job on the tolerances but once you get it in place it will fit without being loose.
The gcode file has all the pieces ready to go but with my printer I could not get that to print all at once without it failing. I had to print each piece individually.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
