Thingiverse
Rocket Ship Container
69
Downloads
110
Likes
1
Makes
Just a cute little rocket ship container I made.
The interior is 106 mm, (just over 4 inches), but you can always scale it up if you want.
In total, it is 175 mm tall (just over 7 inches)
I gave a 0.2 mm pull to the thread, so it should be a good fit for a layer height of 0.2, lower might make it too loose, and higher might make it too tight, but if anyone wants me to adjust the offset to accommodate their print better, just leave a comment or message me.
The interior is 106 mm, (just over 4 inches), but you can always scale it up if you want.
In total, it is 175 mm tall (just over 7 inches)
I gave a 0.2 mm pull to the thread, so it should be a good fit for a layer height of 0.2, lower might make it too loose, and higher might make it too tight, but if anyone wants me to adjust the offset to accommodate their print better, just leave a comment or message me.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
