Rocket Wall Mount

I wanted to hang some of my high power rockets on the wall in my shop, so I did a quick design in Tinkercad for 38mm, 54mm and 66mm rockets (roughly 1.6", 2.1" and 2.6"). I didn't do any structural analysis of these, but I printed with 0.2mm layer height, 3 perimeters and 50% infill. No supports are needed, but the lower screw hole might need a little cleanup. They seem plenty strong to hold up my rockets. There's some discussion about these mounts here: https://twitter.com/GrouchoDuke/status/1579552887017177089

I designed them to use 3/4" wide x 1/16" thick cork tape to help protect the rockets from scratches. I used [Preson P10806](https://www.preson.com/products/p10800-series/), but I don't have a good store link for it. Felt tape will probably work too. Get something with a good tape on the back, so they don't peel up over time. If anyone finds a good supplier, post a comment with a link and I'll share it with everyone.

The brackets are designed to be held in place using two