Thingiverse
Rockshox top cap tool
door Baklin
73
Downloads
44
Likes
1
Makes
I needed to remove the top cap from the airspring on my Rockshox Sid.
This can be done with a cassette tool but mine has a centre pin to locate it on the shaft/cassette.
So I made a new tool for the top cap.
It has a 1/2" socket for a wrench.
I printed it in PLA with 4 outer perimters and it was strong enough to remove the top cap.
The top cap should be torqued to 12.4 Nm/110 in-lb
This can be done with a cassette tool but mine has a centre pin to locate it on the shaft/cassette.
So I made a new tool for the top cap.
It has a 1/2" socket for a wrench.
I printed it in PLA with 4 outer perimters and it was strong enough to remove the top cap.
The top cap should be torqued to 12.4 Nm/110 in-lb
Baklin publiceert ook op
16 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
