Thingiverse
Rode NT1 Offset Mount
por ReallyBigTeeth
7
Descargas
9
Likes
0
Makes
If you like what you see here, consider leaving a tip.
This is an offset mount for a Rode NT1 to keep the weight of the microphone close to the stand.
Update
2024 June 20 - Added a larger base that brings the microphone closer to the center of gravity of the stand.
Designed for use with M3 socket head cap screws, nylon locking nuts, and washers. Reuse the bolt and nut from the original clamp. The printable part has a 5/8-27 thread to attach to standard mic mounts. I had to do some post processing to clean up the parts before fitting the hardware.
This is an offset mount for a Rode NT1 to keep the weight of the microphone close to the stand.
Update
2024 June 20 - Added a larger base that brings the microphone closer to the center of gravity of the stand.
Designed for use with M3 socket head cap screws, nylon locking nuts, and washers. Reuse the bolt and nut from the original clamp. The printable part has a 5/8-27 thread to attach to standard mic mounts. I had to do some post processing to clean up the parts before fitting the hardware.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!