Thingiverse
Roller Shade Fix
von macdaddy
11
Downloads
7
Likes
0
Makes
My roller shade broke a few weeks ago. It's around six feet long and would be over one hundred dollars to replace. The price was just to high. I decided to 3D model and print the part myself to save some money. Hopefully you can download the model and do the same. Below are the printer settings I used.
Printer: Type A Machines Series 1
Plastic: ABS no heated bed
Build Platform: Glass with sanded painters tape @ 23 degrees Celsius
Nozzle Temperature: 239 C
Nozzle Size: 0.5 mm
Slicer: Simplify 3D
Layer Height: 100 microns
Brim: 5 cm
FYI: When using ABS. Sand the tape a lot. If the print fails. Print again ASAP to maintain some heat on the build platform.
For more information go here
http://helpme3dprint.com/blogs/news/13574710-3d-print-a-roller-shade-end-plug
The filament used in this print came from http://www.ORDSolutions.com
The amazing 3D printing software used in this print can be purchased at http://www.simplify3d.com
https://www.youtube.com/watch?v
Printer: Type A Machines Series 1
Plastic: ABS no heated bed
Build Platform: Glass with sanded painters tape @ 23 degrees Celsius
Nozzle Temperature: 239 C
Nozzle Size: 0.5 mm
Slicer: Simplify 3D
Layer Height: 100 microns
Brim: 5 cm
FYI: When using ABS. Sand the tape a lot. If the print fails. Print again ASAP to maintain some heat on the build platform.
For more information go here
http://helpme3dprint.com/blogs/news/13574710-3d-print-a-roller-shade-end-plug
The filament used in this print came from http://www.ORDSolutions.com
The amazing 3D printing software used in this print can be purchased at http://www.simplify3d.com
https://www.youtube.com/watch?v
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!